When talking about the topic of double-opening boxes, the packaging box manufacturers have briefly introduced to you before, whether it is possible to make double-opening boxes is a very simple way to judge the strength of the gift box packaging manufacturers, just whether they can do it is already there. There is a big difference, so if we can do it, let’s discuss it in detail. Do you know what the most critical step or process technology is for double-opening boxes?
Regarding the necessity of magnets, I believe that many people who have seen double-opening boxes or customized design drawings of some relatively high-end packaging boxes will find that most of them will have magnets as an accessory. Of course, the 2pcs base and lid box is a exception. So why are magnets widely used in these high-end packaging cartons? It is actually very simple. The double-opening packaging gift box has one thing in common, that is, if the box itself is stuck by the friction between the inner and outer boxes or the upper and lower boxes, It’s very difficult to keep the box closed, because the double-opening feature makes the contact area of the box different from that of a normal carton. Even if the outer box is picked up vertically, the inner box will not fall out. When it is guaranteed to be used, the double-opening box will not be blocked when it is opened, and it will be relatively wide. Widening will bring a difficulty that is more difficult to overcome by the box itself, and the double-opening box will not close tightly.
In this case, the easiest way to prevent the double-opening box from being opened easily is to install a magnet on the lid box. In fact, there are many ways to prevent the sliding lid or excessive looseness between the inner and outer upper and lower boxes, but there are other methods generally uses more sophisticated technology, more precise and accurate. For example, adjusting the die cut moulds to make them very accurate, and the above situation will not occur, but this is very difficult to realize. It requires not only a very professional die cutting master. In order to adjust to a perfect data state, a lot of materials need to be wasted. If you think about it, a typical size of a beer board needs to be charged 40$, and a larger one is more than 50$. This high-end double-box die cut mould won’t be small. This means you need to pay several of 50$ to adjust the die cut moulds to perfect fit.
Although we are pursuing a high-end double-opening box, it does not mean that it does not matter if such a large amount of cost is spent in order to make this high-end box. If a magnet can be used to fix the lid, only It is necessary to leave a little more space between the upper and lower inner and outer boxes, and this can be accomplished without jamming.
Post time: Nov-23-2021